1. Clock Time Setting
1) Plug in the power cord and locate the bottom buttons.
2) Press and hold the “Clock Setting” until the hour digits flash.
3) Use the “+” and “–” buttons to set the hour.
4) Press “Clock Setting”; the minute digits will flash.
5) Use the “+” and “–” buttons to set the minutes.
6) Press “Clock Setting” to save the settings.
Note: You can press “Clock Setting” to switch between 12-hour and 24-hour formats.
2. Alarm Setting
1) Press and hold “Alarm 1” (bottom button) until the hour digits flash.
2) Use the “+” and “–” buttons to set the hour.
3) Press “Alarm 1”; the minute digits will flash.
4) Use the “+” and “–” buttons to set the minutes.
5) Press “Alarm 1”; the sound number will flash.
6) Use the “+” and “–” buttons to select a sound.
7) Press “Alarm 1”; the volume level will flash.
8) Use the “+” and “–” buttons to adjust the volume.
9) Press “Alarm 1” once more to save the settings. The “Alarm 1” icon will remain on after setup.
Snooze
*Each alarm includes 3 snooze cycles by default. If no action is taken, the alarm runs for 30 minutes, then enters standby mode.
*When the alarm rings, press any button to snooze, or press and hold any button to stop the alarm completely.
*In Snooze status, button presses have no effect. The display shows the remaining snooze time, then returns to the standard clock after 5 seconds.
Note:
*Press “Alarm 1” / “Alarm 2” to turn the corresponding alarm on/off.
*If you forget the alarm time, toggle the alarm off and on again to flash the set time on the clock.
*If no buttons are pressed for 30 seconds during setup, the settings save automatically and the device exits setup mode.
*To set Alarm 2, repeat the same steps using the “Alarm 2” button.
